How to Roll a Diamond Joint

Need help, or have you perfected a revolutionary technique & wanna share it?

Moderator: Moderators

Post Reply
User avatar
Weedguru Higher
Tetrahydrocannabinologist
Tetrahydrocannabinologist
Posts: 14627
Joined: Sun Mar 30, 2003 1:31 pm
Location: Canada
Contact:

How to Roll a Diamond Joint

Post by Weedguru Higher » Sat Mar 13, 2010 8:58 pm

How to Roll a Diamond Joint

Once mastered, the joint rolling technique opens a realm of possibilities for weird and wonderful creations. The Diamond is a good place to start and when made with care smokes surprisingly well.


Roll a straight, fat joint with a sturdy roach and carefully cut it in two, using a pair of scissors or a knife. One piece must be slighty longer than the other
Image
Roll two identical joints, without roaches and slightly thinner than the first. Put slightly less mix in their centers so that you can bend them later on. Consistency is important here, the joints must burn at the same rate.
Image
Carefully trim away any excess paper from all four joints, leaving the mix flush with the paper.
Image
Cut the gummed strips from ten spare papers (the wide strips from king skins are best) and put to one side.
Image
Now for the tricky bit... Join the two identical joints to the segment of the first joint containing the roach. Use some of the gummed strips to bandage the join as shown. It is best to do this on a flat surface. Keep bandaging until you are confident everything is airtight and secure.
Image
Very gently, bend the two joints at their centers until they meet to form a diamond shape.
Image
Finally, bandage the joint to the remaining at the end of the diamond, using the gummed strips as before.

Image Image
Image

Post Reply

Who is online

Users browsing this forum: No registered users