By Ganja
Here's a visual guide to pressing resin powder into solid hash.
The example here starts with medium-high quality water-hash powder, which probably presses more easily than most types of resin. However, with this method, all but the lowest quality resin will stick together in the end.
This method is good for anything up to a few grams of resin.
Now, after ten minutes of twisting and heating by rubbing on your jeans(on your thigh):
The dark section on the front of the above image is the surface where the hash was rubbed against fabric.
BTW - the ragged edges you can see on the cellophane wrapper are from rubbing the twisted hash on fabric - which creates a nice gentle heat source. Just don't rub too hard, or you'll end up smearing half pressed hash on your jeans.
http://forum.hashmuseum.com/forum_posts.asp?TID=2963
