
I used:
- 1 .07mm HB mechanical pencil
1 Bic gel pen (the regular ball point are better, i couldn't find out)
A bit of the clear scotch tape
A 591mL pop bottle
Silly putty as a sealant
1 bag of weed
The bowl from my pipe

The side that you write with is stuck in the bottom of the bowl. The resin helps make it stay in better.

Screw the bowl and stem onto the bottle cap that you cut a hole in.

Screw the cap on, load up a bowl and you're set!
I'm always preaching about how great silly putty is. It stays on so much better than tape and it seals more airtight than tape.
I decided to go into details because not everyone out there knows how to make a good pop bottle bong.



