Page 1 of 1
ph levels
Posted: Wed Jun 15, 2005 1:09 pm
by kevh44
how do i control the ph levels in my nutrient solution it constanly rise's every 24 hours even though it has been balanced previously im useing clay pebbles and a wilma system. advice would be greatly appreciated
Posted: Wed Jun 15, 2005 7:37 pm
by Weedguru Higher
I have no experience whatsoever with the wilma system. I can only attempt to help you out by saying this : If the pH is too high, adding a solution with nitric or phosphoric acid (pH down) will lower it. If the pH is too low, a solution with potassium hydroxide (pH up) will raise it.
Posted: Thu Jun 16, 2005 8:59 am
by Weedguru Gooster
kevh,
Didnt I post an answer for you or am I finally cracking up? I could swear I wrote a fucking ESSAY on ph today?
Goo
Posted: Thu Jun 16, 2005 9:28 am
by Weedguru Higher
You did Gooster. Same question was asked in another thread. You are still sane.
ph levels
Posted: Thu Jun 23, 2005 2:07 am
by kevh44
cheers goo for the help seem to be getting the levels under control
