How to make a kick ass gravity bong.
Posted: Fri Sep 26, 2003 1:48 pm
Here's all you need to make a kick ass gravity bong.
---1 large bottle of your choice (preferably a 3 liter or a big apple juice container).
---1 good sized bucket(maybe 8 inches thick and about 7 inches tall)
aluminum foil (always a life saver
)
---1 safety pin
---tape
---Knife
instructions:
Take your bucket and fill it up all the way except like 2 inches. Cut the bottom part of your bottle off. Take the cap off and place bottle in water so you can check how much room there is for smoke when you pull. Take your pocket knife and cut a good sized hole in the lid. Now take your aluminum foil bend it so that its on top of the lid and goes down in the hole. Next tape the aluminum foil to the cap. After that take your safety pin and poke little holes all in the aluminum foil. This is your bowl (trust me this works better then putting an actual bowl on top). Put the cap back on the bottle and let it sink in it. Take your weed and place it in the bowl. Grab a lighter and light your weed while you slowly pull up on the bottle. If its air tight and everything goes according, when you pull the bottle out of the water it shoudl fill up with clouds of smoke. Unscrew cap and enjoy!
Here's the part for the nerds like me that explains how it works. If you know anything about physical science you'll know that matter cannot be created or destroyed. When you pull the bottle out of the water water leaves the bottle but somthing has to go in its place normaly it would be the air around us but sence the only vent the bottle has smoke it fills up with smoke instead of air. Neet huh?
---1 large bottle of your choice (preferably a 3 liter or a big apple juice container).
---1 good sized bucket(maybe 8 inches thick and about 7 inches tall)
aluminum foil (always a life saver
)---1 safety pin
---tape
---Knife
instructions:
Take your bucket and fill it up all the way except like 2 inches. Cut the bottom part of your bottle off. Take the cap off and place bottle in water so you can check how much room there is for smoke when you pull. Take your pocket knife and cut a good sized hole in the lid. Now take your aluminum foil bend it so that its on top of the lid and goes down in the hole. Next tape the aluminum foil to the cap. After that take your safety pin and poke little holes all in the aluminum foil. This is your bowl (trust me this works better then putting an actual bowl on top). Put the cap back on the bottle and let it sink in it. Take your weed and place it in the bowl. Grab a lighter and light your weed while you slowly pull up on the bottle. If its air tight and everything goes according, when you pull the bottle out of the water it shoudl fill up with clouds of smoke. Unscrew cap and enjoy!
Here's the part for the nerds like me that explains how it works. If you know anything about physical science you'll know that matter cannot be created or destroyed. When you pull the bottle out of the water water leaves the bottle but somthing has to go in its place normaly it would be the air around us but sence the only vent the bottle has smoke it fills up with smoke instead of air. Neet huh?
)