Page 1 of 1
pimp c02 pipes
Posted: Sun Dec 07, 2003 4:33 am
by Zer0orDie
i was just shooting my bb gun and need 2 change my c02 cartridge so i was looking at it and made a pimp little pipe outta it. i took 2 empty 12 gram cartridges and cut one of the ends off so i had a little bowl. i drilled a hole in the other cartridge and stuck the bowl in the hole and there ya go. a pipe.
Posted: Mon Dec 08, 2003 11:54 pm
by magicmaster141
what did you use to cut it? If I remember right that sounds hard.
Posted: Tue Dec 09, 2003 3:06 am
by AlucarDracula
hack saw probably thats wut i use when i made my vapourizer and for cutting through copper tubing
Posted: Tue Dec 09, 2003 4:10 am
by Zer0orDie
i used my dremel thing. it has these cut off discs that cut like everything.
i polished it and shit and it looks cool as hell. pocket sized
Posted: Tue Dec 09, 2003 9:40 pm
by weedwolf
man i should try that
but what if there is air in da shit
wouldnt it splode
Posted: Tue Dec 09, 2003 11:41 pm
by Zer0orDie
i dont think it would "splode" but it would shoot ice cold air out for about 15 seconds. it looks awsome and works pretty good
Posted: Wed Dec 10, 2003 5:45 pm
by weedwolf
wouldnt it be great if you could hook it up so that the co2 gives you a hoot
but you dont hoot the co2
Posted: Wed Dec 10, 2003 8:01 pm
by Zer0orDie
weedwolf wrote:wouldnt it be great if you could hook it up so that the co2 gives you a hoot
but you dont hoot the co2
ya i was thinkin the same thing
Posted: Wed Dec 10, 2003 10:49 pm
by GodHand Kronix
Damn I must have some old Co2 cartridges laying around my room somewhere. Thanks for the idea bro