www.weedguru.com

ive been makin pop bottle bongs and parachutes for me an my friends for years now and id like to step it up a notch in the quality department so a hawked a beaker from my science class i promptly began design and planned for how im going to make it a masterpiece when i realized have have no clue how to cut a hole in glass... a friend told me a blow torch and a straw would do the trick by heating it up and blowing out a hole but im a bit skeptical.. ne ideas as to how i shoudl attack this would be wonderful

ur friends right, but its too much of a mission to do, so just buy a proper bong.. itll prolly work better and its easier

just buy one man, if not use a glass cutter or glass drill bit

failing that put a small coin inside and wing it around. dont expect a clean cut hole, but its somin to work with i guess (shield ur eyes when doing this foo)

i have a few store bought bongs but i feel like i need a good glass homemade one to add to the collection

well if you copped it from your science class its most likely 'pyrex' which is a special glass that withstands fire up to a fuckin high point.