www.weedguru.com

av u eva rolled a joint that looks nice but you cant get a good toke on it, its fukin annoyin, do u know how to sort that shit out

use ur sproid u use for bonging or something similar to poke thru the roach, gently making sure u dont go to far.. then get a lighter and flame the end of the roach burning the paper around it off and it shud toke..

when i say burn the paper around the roach i mean burn the end bit not ALL the paper around the roach.. lol and when i said use something to poke it thru it must be hella thin, thinnner than a biro im talking flux thin but not thin so it falls apart str8 away

Wow dude...I have no idea what you just said...

lol

lol basically put a wire or something thin thru the roach making sur etheres a gap so u can toke it, then flame the end of the roach where u put ur lips so the paper burns away, dont burn all the paper, burn it a little

capiche?

fanx for da info did it earlier it was smooth as hell

wen u rip the roach burn along the sides so that it dont trap resin

yo i did all that to my last cone and it smoked wonderfully but i still cant figure out why i burned the end bit of th roach i mean it worked and all but why was that neccesary?

only to burn off the joint paper, that over hangs the roach (paper filter) so it keeps nothin` back.

Ok underneath ; the worst digital joint ever, left is the roach

__________________________________
/[ roach] ]
\[_____ ]___________________________ ]

no see those / \ things "hanging" from the left end of the roach??thats the excess paper, burn that off, it will clear the back of the roach for better ability to inhale the smoke.

It could also just be that u roll to tight roaches, and in that case just use a wider one next time


hope this helps