Make A Lightbulb Vaporizer

[WeedGuru_Flow]

so basically you take a clear lightbulb, find a cap that matches the hole when you pull out all of the iron wiring and shit and screw it on, then make a hole in the cap.

Then put weed in the lightbulb, screw the cap back on, hold it comfortably and light until the fumes have filled the bulb and then proceed to inhale?

[swanee89]

yea, have a nice knife and a pair of pliers handy as getting the socket part of is a bitch. also, make sure you get rid of the inside covering if it has any. i just poured some salt in, swirled it around for a while and poured it out. then you have a perfectly clear and clean bulb. any caps fit, i think. the first one i grabbed fit, which was off of an aquafina bottle, so that shouldnt be a problem.

also, dont forgot the straw, put that in the hole to make it easier to use and make a carb on the cap too. so there should be 2 holes in your cap. your going to have to manage this space but it can be done, trust me.

my tip: forget about lighters, that will take too long. use a candle! i used those little tea candles or whatever cause they were cheap. 2 bucks for 50 of them!

[Cat_ScrAtch]

Stop heating it a little bit before the bulb is filled, the remaining heat should be enough to finish filling the bulb with vapor and not burn your weed.

[SQUEEZABLE]

. Joints are definitely better but it's not bad for a change I guess.

what, a better high????

[swanee89]

its just different, and more efficient

[sp0rkeh]

just made one after reading this, SO WORTH IT.

took maybe 15 minutes with no difficulties at all.

but for heating the bud, i just make it till i see smoke starting to swirl then i take flame away and let it fill the rest of the way with the heat in the glass?

and it should look all smokey inside correct?

[Cat_ScrAtch]

just made one after reading this, SO WORTH IT.

took maybe 15 minutes with no difficulties at all.

but for heating the bud, i just make it till i see smoke starting to swirl then i take flame away and let it fill the rest of the way with the heat in the glass?

and it should look all smokey inside correct?

more "whispy" than smoky. like water boiling.


smoke is what you don't want.

[sp0rkeh]

alright, so smoke is bad, very light vapors in it = good?

[t3h_shitz]

alright, so smoke is bad, very light vapors in it = good?

Fo sho

To get the black nub at the bottom of the metal threads out I just took a wire cutter and put it in the last set of threads and cut it, almost like paper. Anbd be really careeful when leaning the green/yellow hard crusty shit around the metal threads on the inside. There is a layer of glass protecting it, and if you break that, you have to start all over.

[Funk Doctor]

How long do these bulb vaporizers last?

[stnrstan]

I made one last night and tried it out. I made me cough like a bitch the first several hits but once I got used to it it wasnt so bad. There wasnt any weed smell but there was a kind of chemical smell from burning the lightbulb but it wasnt bad.